WanPower 0.3mm Drill Bit for 3D Makerbot Printer Nozzle Cleaning + 0.4mm Printer Extruder Brass Nozzle Print Head for MK8 Makerbot, Pack of 5 Sets
Product Description
WanPower 0.3mm Drill Bit for 3D Makerbot Printer Nozzle Cleaning + 0.4mm Printer Extruder Brass Nozzle Print Head for MK8 Makerbot, Pack of 5 Sets
- Cleaner will clear nozzles and produce better prints.
- 0.3mm cleaner suits for cleaning 0.4mm nozzles.
- Extruder nozzle: 0.4mm. Input diameter: 1.75mm.
- Material: copper (brass). Size: 8*13mm
- 5 sets of nozzles and cleaners.
Nozzle cleaner
Extruder Nozzle Cleaners are an essential item for any 3D printer owner. Every extruder nozzle must be cleaned out from time to time, but very difficult to clean properly.
The drill bit is of the highest quality. It is the perfect tool for the job.
By using it, the life of your nozzles will be extended and without a doubt, produce better prints.
Specifications:
Bit diameter: 0.3mm
The bit length: 15mm
The length of shank: 20mm
Note:
Don't use the drill to clean until the nozzle is heated to above 200 degrees!
If you need another size or have any questions, contact us and we will take care of you.
Nozzle:
The nozzle material uses the national standard copper (brass).
Compare with the non-national standard copper, it has obvious differences, our nozzle's thermal conductive performance is better than the non-national standard of copper.
This product is for MK8 Makerbot 3D printer, also compatible with Ultimaker. It only suits for 1.75mm filament.
Specification:
Nozzle: 0.4mm
Material: copper (brass)
Input Diameter: 1.75mm
Output Diameter: 0.4mm
Size: 8*13 (mm)
