onelinkmore TNC Male Crimp Connector 10-Pack — 50 Ohm for RG58 RG142 RG400 LMR195 KSR195 3D-FB Cable, Gold-Plated PTFE for GNSS GPS Survey Antenna, Trimble, NanoVNA, RFID, Cable Repair

onelinkmore TNC Male Crimp Connector 10-Pack — 50 Ohm for RG58 RG142 RG400 LMR195 KSR195 3D-FB Cable, Gold-Plated PTFE for GNSS GPS Survey Antenna, Trimble, NanoVNA, RFID, Cable Repair

• FITS 6 CABLE TYPES — RG58 / RG142 / RG400 / LMR195 / KSR195 / 3D-FB: Precision-machined to the dimensional tolerances of all six common 50-ohm coaxial cable standards used in RF communications: RG58 (general purpose), RG142 / RG400 (semi-rigid military-grade), LMR195 / KSR195 (low-loss flexible), and 3D-FB (standard equivalent to LMR195). Each connector ships with the correct ferrule for a secure crimp without voids or movement at the cable-connector interface.
• GOLD-PLATED PTFE — 0.15dB INSERTION LOSS, VSWR ≤ 1.2: Center pin is machined brass with heavy gold plating for maximum conductivity and oxidation resistance. PTFE (Teflon) dielectric insulator maintains stable 50 Ohm impedance and minimizes dielectric loss across the rated frequency range to 3 GHz. Measured insertion loss ≤ 0.15dB. VSWR ≤ 1.2. Nickel-plated brass outer shell resists corrosion in outdoor and high-humidity survey environments.
• PURPOSE-BUILT FOR GNSS / GPS SURVEY ANTENNA CABLE ASSEMBLY — TRIMBLE COMPATIBLE: TNC Male is the standard connector on professional GNSS survey antenna cables used with Trimble R-series, Leica GS-series, Topcon HiPer, and Sokkia receivers. These connectors are used by surveyors and GIS professionals for custom-length antenna extension cable fabrication and field cable repair — replacing damaged connectors on existing LMR195 or RG58 antenna cables without replacing the entire assembly.
• CRIMP-TYPE INSTALLATION — REQUIRES CRIMP TOOL, NO SOLDERING: This is a crimp-type connector assembled with a standard RG58/RG142/LMR195 crimp tool (UG-style die, 0.068"/0.213" jaw). Assembly sequence: strip cable to spec → slide ferrule onto cable → insert cable into connector body → crimp ferrule. No soldering required. Compatible with Pro'sKit CT-9A12, Paladin PA1560, and any standard coax crimp tool with the correct die set for RG58-family cables. Each pack includes 10 connector bodies and 10 ferrules.
• WIDE RF APPLICATION — NanoVNA, RFID READER, WLAN, INDUSTRIAL IoT: TNC Male crimp connectors are used wherever a field-terminable, vibration-resistant RF connection is needed: GNSS/GPS survey antenna cables, RFID reader antenna ports, NanoVNA and RF test equipment cable fabrication, industrial WLAN and WiMAX antenna installations, SCADA system antenna runs, and LMR land mobile radio infrastructure. NOT RP-TNC (Wi-Fi). Standard TNC Male with center pin — mates with TNC Female jacks on antennas, instruments, and bulkhead feedthroughs.