Swhacker #203 Replacement Blades | 1.75″ Cut | Stainless Steel, 6-Pack | Restore Sharpness & Performance to Your Broadheads
Product Description
Swhacker #203 Replacement Blades | 1.75″ Cut | Stainless Steel, 6-Pack | Restore Sharpness & Performance to Your Broadheads
- 100 Grain Broadhead Repalcement Blades with Extra Shrink Tubing
- .032" think, stainless steel, honed razor sharp
- 1" in flight - 1.75" after penetration
- Set of 6 Blades
- Set of 6 blades
- 100 Grain Blade
- Blade: .032" thick, stainless steel, honed razor sharp
- 1 inch in flight -1.75 inches after penetration
- Includes extra shrink tubing
To install Swhacker replacement blades-insert blades into the slot of the ferrule (the arrow head). Secure in place with the setscrew. Ensure that the blades rotate freely from open to closed. Install shrink tubing by placing a single band over the tip with the blades fully enclosed in the slot. Slide the band down the ferrule until it is in the slot. Slide the band down the ferrule until it is in the retaining groove. The blades may move slightly. If the band does not stay in the retaining groove, use a heat source such as a pocket lighter or a hair dryer to shrink the band down. Care should be taken to not overheat the band. CAUTION: This product is EXTREMELY sharp. Serious injury can occur if handled improperly. Please follow the instructions carefully.









