Sunco 12 Pack 4 Inch Remodel LED Can Light Housings, 18W Max

Sunco 12 Pack 4 Inch Remodel LED Can Light Housings, 18W Max

• ⭐ CUTS INTO A CEILING YOU ALREADY HAVE: The Sunco 4 Inch Remodel LED Can Light Housings install through a ceiling that is already finished, with no attic access and no opening up the drywall from above. You cut the opening from below, run the wiring, and set the housing into that opening from the room side. That is what separates a remodel can from a new construction can, which has to go in before the drywall is hung. It is why these 4 inch recessed can lights are the style homeowners and electricians reach for on an upgrade, a room refresh, or any job where the ceiling above is already closed in.
• ✅ HOUSINGS ONLY, SO THE TRIM IS YOUR CHOICE: These 4 inch remodel can lights are sold as housings, so the trim or LED retrofit module is a separate purchase. That is deliberate. One can light housing can take a baffle trim in a hallway, a gimbal over a reading chair, or an eyeball trim aimed at a piece of art, all from the same opening. Set the recessed can housing into the ceiling now, then choose the finish, beam, and color temperature once you can see how the room is actually going to be used.
• ✅ SIZED FOR STANDARD 4 INCH TRIMS: The 4 inch aperture on these remodel can light housings is a standard recessed size, so the cans accept common 4 inch trims and LED retrofit modules instead of tying you to one proprietary part. That keeps a small hallway, a closet, a stairwell landing, or a tight ceiling bay in proportion, since a 4 inch recessed can reads as a discreet point of light rather than the wide ring a 6 inch can leaves behind. Replacing or restyling the trim later is a five-minute job when the housing takes a common size.
• ✅ STEEL BUILD ON A 120V THROUGH 277V RANGE: Each 4 inch remodel can housing is built from steel, so it holds its shape as it seats into the ceiling opening and stays square once it is wired. The wiring on these recessed can lights accepts anything from 120V to 277V, which covers standard residential circuits and the higher-voltage runs found in light commercial ceilings. One part number therefore works across a house, a rental unit, or a small commercial remodel without switching to a different housing.
• ✅ MULTIPLE CANS FOR A FOCUSED ROOM OR RUN: Multiple 4 inch recessed can light housings arrive in the pack, sized for a hallway run, a closet, a small bedroom, or a single accent zone rather than a whole floor. That count matters on a remodel job, where you are usually replacing or adding lights in one room at a time instead of wiring an entire new build in one pass. Each housing weighs a little over a pound, is UL listed, and is intended for indoor ceilings.