Seymour Duncan Ts-2 Triple Shot Carved Top Pickup Mounting Ring Cream Neck
Product Description
Seymour Duncan Ts-2 Triple Shot Carved Top Pickup Mounting Ring Cream Neck
- The Triple Shot switching mounting ring is amazing for a variety of reasons. You get tons of tonal variety from the four different sounds it gives you (splitting to either coil, series operation, and parallel operation). You are able to easily switch between the various sounds with just the flip of your finger. No more reaching for pushpulls there are two small slider switches at the low E-string edge of the ring for easy access. And, the Triple Shot is incredibly easy to hook up.
- No more fumbling with pushpull or mini-toggle connections—the Triple Shots color-code labeled solder pads are a snap to solder up. Imagine having coil splits on your 335 without having to pull the harness, and struggle to get the pots back in the right place One ring for each pickup means four sounds per humbucker. The combinations are almost endless.
- This version is for guitars with arched tops. With this version, the neck & bridge rings are different heights.
- Handmade in Santa Barbara, California: Seymour Duncan takes pride in designing and crafting our products to create the most amazing sound possible. That starts with providing an environment that attracts and retains our great team of engineers, product designers and craftsmen, many of whom have been with the company for decades.
- 0
The Seymour Duncan TS-2 for Les Paul Neck Humbuckers allows you to expand your tonal palette by accessing three unique tones from a humbucker, thanks to the TS-S mounting ring that holds two small switches. For use with nearly any humbucker pickups with four-conductor cable on Les Paul guitars, Seymour Duncan or otherwise. This "stealth" pickup switching device allows you to access series, parallel and split wirings with a standard humbucker. And it's easy to install. Just solder your pickup leads to a small color-coded circuit board. That's it. Push the two switches towards each other for standard series wiring; away from each other for parallel wiring; and both towards one coil (either one) to shut that coil off. Specifications Inside: 2.780 x 1.470 inches Outside: 3.54 x 1.78 inches Pickup mounting hole spacing: 3.076 inches on center Trim ring mounting hole spacing: 3.20 x 1.513 inches on center Height: 0.200 inches (ring), 0.328 inches (switch casing) Circuit board: 1.353 x 0.402 inches Soundboard radius: 43.5 Note: Will not fit Nickel and Gold covered Trembuckers.
