SENSKY BS010H 12V 24V DC Motion Sensor Light Switch - Black PIR Occupancy Controller with 3A Load Current Plus Adjustable Delay and Distance - for Kitchen Cabinet Pantry Closet and LED Tape

Description

PIR(Passive infrared) Motion sensor is pyroelectric device can detect human movement by detecting Infrared ray emitted by human body. Operating voltage is 5~25VDC, and output voltage is equal to input voltage. High sensitivity, Easy to install.
Automatic Induction

When people enter into the sensing range, Motion sensor will output a voltage equal to input voltage, after the delay time, it will output 0V; During the delay time if motion detected, the delay time will reset, and start a new delay time.
Application

Widely used on the Motion-activated lighting, LED strips Security System, automatic sensory device and more.
< Specification

Passive Infrared Sensor
Operating voltage DC: 12V
Load current : 3A
Delay time: Default setting 5-25s (2~280 Seconds adjustable)
Detecting range ≤ 110 degrees cone angle
Detecting distance4M-7M (10cm-7M adjustable)
Trigger way : Continuous triggering
Blockade time: 0 seconds
Size: 48*25*14 mm
Delay time adjustment: Clock-wise reduce the delay time , Anticlockwise increase the delay time
Sensor distance adjustment: Clock-wise increase the Sensor distance, Anticlockwise reduce the Sensor distance

Note:

1. The PIR Sensor requires a 'warm-up' time in order to function properly, about 10 s to1 min, depending on the delay time; during this time, the signal triggered by the module is not stable, after one minute, it will be ready.
2. Don't expose the Sensor Switch to direct sun light /lighting, big wind, or placing near to a heater or air condition.
3. Don't fix the item at a place where there are obstructing material (eg. Glass, dense clothes) which IR cannot get though.
4. Don't fix the motion sensor switch in strong shock or vibration environment.