SODIAL Cloned Re-Arm 32 Bit Control Board Improved Based On Mega 2560 with Card for Ramps 1.4 1.5 1.6 3D Printer Parts

* SODIAL is a registered trademark. ONLY Authorized seller of SODIAL can sell under SODIAL listings.Our products will enhance your experience to unparalleled inspiration.
Maximum current: 1.2A
Frequency: 100MHz
Controller: 32-bit
Flash: 512K
Feature: With Card
Usage: For 3D Printer
1.Easy configuration using a text file on card, no need to upload firmware every settings change
2.Capable of running smaller micro-step stepper drivers. Like the 1/128 micro-stepping SD6128 driver.
3.Ethernet RJ45 add-on Module
4.Run graphic LCDs with your Deltas without hiccups.
5.Run 2 cards, one for settings and firmware(on board) and the other for file loading (on LCD).
Note:
1.please pay attention to the jumper cap of the power supply;
2. Do not Pressthe motherboard with wet hands;
3. When uploading firmware, you need to connect the HWB jumper cap;
4. In the event of an emergency, please disconnect the power immediately to avoid burning the motherboard;
5. Do not use the motherboard in a humid environment;
6. Please check whether there is a short circuit in the line before power-on. If there are
conditions, it is better to use a multimeter to measure and then power on;
7. This motherboard does not support the use of the TMC2130 SPI mode.
colour:Black
Material:plastic
size:Base plate 15*10*4cm
Package Contents:
1 * RE-ARM 32-bit control board
1 * USB cable
Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.