SMALLRIG 5" Electric Camera Suction Cup Mount Kit with Magic Arm with Ball Head for Vehicles, 2000mAh Battery, Type-C, Electric Motor, Camera Car Mount for GoPro, for DJI, for Insta360-5399

SMALLRIG 5" Electric Camera Suction Cup Mount Kit with Magic Arm with Ball Head for Vehicles, 2000mAh Battery, Type-C, Electric Motor, Camera Car Mount for GoPro, for DJI, for Insta360-5399

• High Performance Electric Motor: Equipped with a high-performance motor, the response time is less than 100ms, allowing for quick suction and enhancing assembly efficiency. It features a built-in pressure monitoring module that can monitor in real-time. When the pressure inside the suction cup drops below 75%, automatic inflation is triggered to ensure the safe adhesion of the equipment
• Built in 2000mAh Battery: The suction cup mount contains a 2000mAh battery that supports QC protocol and is powered by 5V/2A Type-C. It can be fully charged in 45min and the durable built-in battery can work continuously for 30H, meeting your uninterrupted shooting needs
• Superior Suction Power: The suction cup mount can be one-touch auto-adhesion, allows instant attachment without manual effort, enhancing shooting efficiency. When vertically (on the side) mounted, it can support up to 40kg, and when horizontally mounted, it can support up to 60kg. For use in vehicles, it is recommended to use a safety hanging rope, maximum load of 5kg, and to keep the vehicle speed below 80 km/h. Note: Users must verify surface compatibility and monitor adhesion status regularly (every 2 hours) during use.
• Multiple Installation Points: Including anti-twist 1/4"-20 and 3/8"-16 threaded holes, as well as 3/8"-16 locating holes for ARRI, This versatility allows for attaching magic arms for action camera mounting or securing the safety tether for dynamic shooting. The suction cup comes with a dust cover to prevent dust accumulation when not in use, prolonging its lifespan. Note: Exercise caution when attaching to surfaces with protective films.
• Lightweight & Durable Material: The main body of the suction cup is made of nitrile rubber, and suction cup expansion base is made of aluminum alloy, sturdy and wear-resistant, suitable for high and low temperatures (-25~60°C), resistant to deformation, with good sealing and high abrasion resistance. Note: It is only suitable for use on smooth, dry, flat surfaces. Rough, wet, uneven, dirty, fragile, or easily damaged surfaces should be avoided
• Notes: 1.Keep the suction cup base and filter foam clean and intact. Discontinue use if compromised. 2.Operate within -25°C to 60°C (-13°F to 140°F) ambient temperatures. Excessive heat may cause battery swelling, fire, or explosion. For cold environments, fully charge the battery at room temperature before use to maximize lifespan.