Rack-A-Tiers Chip Catcher - Magnetic Metal Drill Chip Collector, Metal Shavings Catcher, Metal Drill Shaving Catcher for Electrical Panels, Electrician Job Site Cleanup (84100)

Rack-A-Tiers Chip Catcher - Magnetic Metal Drill Chip Collector, Metal Shavings Catcher, Metal Drill Shaving Catcher for Electrical Panels, Electrician Job Site Cleanup (84100)

• Can be used while drilling holes up to 3/8” in size
• Inside diameter of the larger hole is 2”
• LESS MESS – The Chip Catcher not only makes collecting metal shavings simple, but also takes the hassle out of disposal. No more trying to vacuum the metal chips and hoping to get them all. It would normally be difficult to clean metal shavings off a magnet, but the Chip Catcher has a separate plastic sheath between the magnet and the metal chips. Removing the metal shavings can be done in seconds, simply slide the inner piece away from the magnetic outer shell and the shavings fall off.
• SAFETY – Trying to clean up metal shavings by hand can be risky as the sharp chips can easily cut your fingers. Injuries like that can affect your ability to work and any steps to avoid them should be taken. With this magnetic chip collector, you can collect and dispose of your metal debris without ever touching it, making your job safer.
• PROTECTION – Magnetic chip collectors are a fantastic way of protecting your valuable components from potentially harmful metal shavings. Hot metal chips can cause permanent damage to delicate electrical components like controls, breakers, switchgear, terminal blocks, contactors, and relays which often leads to serious problems and a lot more work. The Chip Catcher does a much better job of dealing with magnetic shavings than other methods.