Orca Shimmer Mold Release Compound High Gloss Paste Wax

Orca Shimmer Mold Release Paste Wax:

• Highly effective carnauba-based paste wax designed for the fiberglass molder.

• High value mold release yielding a durable film which is resistant to abrasion.

• Three to five coats of Orca Shimmer should be applied initially on clean or new molds.

Application:

1. Apply Orca Shimmer to a small section at a time (9 square feet or one square meter) until the entire mold surface is covered.
2. Allow the wax to form a haze on the surface.
3. Wipe the surface with a clean cloth to remove excess wax.
4. Buff each coat to a high luster.
   
   

After this initial application, single coats will continue to give a good release and high surface luster. In high humidity, it may be necessary to give the mold a final wiping with a clean, dry cloth to remove any haze that develops from unreleased solvents. In order to avoid contamination, a clean cloth should always be used when applying and buffing this product.