ENGINEER 123mm Full Flush Cut Chip Cutters. Made in Japan. 45 Degree Angled Jaws Cutting Pliers for Removing ICs, Chip Resistors, Electronic, SMD Components. NZ-05
Product Description
ENGINEER 123mm Full Flush Cut Chip Cutters. Made in Japan. 45 Degree Angled Jaws Cutting Pliers for Removing ICs, Chip Resistors, Electronic, SMD Components. NZ-05
- 45 Degree Angled Jaws ideal for snipping Electronic Components, Chip Resistance, Integrated circuits, etc on dense S.M.D.
- Jaw Opening Angle Adjuster (Max.5mm): 1.5mm hex key wrench provided as a standard accessory to adjust an opening angle and fasten the screw.
- ESD-Safe handles made of thermoplastic rubber (TPR) with strap holes. Coiled spring loaded for reduced hand fatigue.
- ・Cutting Capacity: Copper wire (Solid wire)/φ0.6mm・Surface Resistivity ：Grip/1×10⁶～10⁷Ω
- ・Length: 123mm ・Handle Width: 51mm ・Weight: 67g
Specialized cutters designed to remove unwanted components from an SMD or through hole PCBs, thereby allowing for easy desoldering/cleaning of the associated component PCB pad. Ideal for cutting the leads of D.I.P. and S.I.P. on densely populated SMD PCBS. Long-life carbon steel jaw construction, specially designed to prevent the pivot joint loosening or the blades going out of alignment. Opening angle adjuster (this sets the jaw gap when the handles are released - 1.5mm hex key supplied). ESD-Safe comfort grips made from TPR (Thermoplastic rubber). Cutting capacity - 0.6mm copper wire.
