MyoWare 2.0 Power Shield- Designed to Power The MyoWare 2.0 Muscle Sensor-Remote Applications-Power Switch-Built-in LiPo Battery 40mAh-3.7V-Built-in LiPo Charge IC-Board Dimensions 2.10in x 2.35in

MyoWare 2.0 Power Shield- Designed to Power The MyoWare 2.0 Muscle Sensor-Remote Applications-Power Switch-Built-in LiPo Battery 40mAh-3.7V-Built-in LiPo Charge IC-Board Dimensions 2.10in x 2.35in

• Note: Ecosystem is not intended for use in the diagnosis of disease or other conditions, or in the cure, mitigation treatment, or prevention of disease, in a person or other animals
• Note: Board only, additional accessories will be needed; Board Dimensions: 53.34mm x 59.69mm (2.10” x 2.35”)
• Input Voltage: 5V via USB Type C Connector; Output Voltage (e.g. "VIN"): Nominal Voltage: 3.7V, Fully Charged: 4.2V; Power Switch; Built-in LiPo Battery: Rated Capacity: 40mAh, Nominal Voltage: 3.7V; MCP73831 Single Cell LiPo Charge IC: Charge Rate Set to 40mA
• Note: Always remove the MyoWare 2.0 Power Shield from the MyoWare 2.0 Muscle Sensor whenever you are charging its LiPo battery with a computer or USB Charger
• The MyoWare 2.0 Power Shield was not designed to be used with the MyoWare 2.0 Muscle Sensor while charging; If the power switch is in the ON position while you are charging, it will compromise the integrity of the output signal