Miuzei Sg90 9g Micro Servo Motor for Arduino RC Car Robot Boat Plane 5Pcs
Product Description
Miuzei Sg90 9g Micro Servo Motor for Arduino RC Car Robot Boat Plane 5Pcs
- SG90 9G digital Servo - Miuzei 9g servo motor for remote control helicopters, micro robot, robot arm and boats. Fit for ALL kinds of R/C car and also make electronics DIY compatible with Arduino, Raspberry Pi.
- Mini Servo - small servo motor compatible with JR and Futaba interface. Micro servo running speed (at no load) : 0.09 sec/60° (4.8V) 0.08 sec/60°(6V). Running angle: 180 degree.
- Micro Servo Motor - Stall Torque (4.8V): 19.6 oz /in (1.4kg/cm). Dead band width: 5 usec. Operating Voltage: 4.8V-6.0V.
- Application Fields -Servos used for drone, DIY project, RC crawler, helicopterfixed-wing, helicopter, KT, glider, small robot, robotic arm and other models.
- Note - Starting current of the analog servo motor should be over 1A and servo sg90 are analog servos need to continuously provide a PMW signal, then it will be work normally.
Miuzei SG90 9G Micro Servo Motor Kit for RC Robot Arm Helicopter Airplane Remote Control
Product Specification
Mode Number：MS18
Control Specification：
Control system:Change the pulse width
Amplifier type:Analog controller
Operating trave:l120°±10° (900→2100 μsec)
Left&Right travelling Angle deviation:≤ 6°
Centering deviation:≤ 1°
Neutral position:1500 μsec
Dead band width:7 μsec
Rotating direction:Counter Clockwise (900→2100μsec)
Pulse width range:900→2100 μsec
Maximum travel:About 120° (900→2100 μsec)
Apply Environmental Condition：
Operating Temperature Range:-10℃～50℃
Operating Voltage Range:4.8V～6.0V
Electrical Specification (Function of the Performance)：
Operating speed (at no load) 0.09±0.01 sec/60°(4.8V ) 0.08±0.01 sec/60°(6V)
Running current (at no load) 400±30mA (4.8V ) 500±30mA(6V)
Stall torque (at locked) 2.0±0.20kg·cm (4.8V ) 2.2±0.20kg·cm(6V)
Stall current (at locked) 1300±40mA (4.8V ) 1600±50mA(6v)
Idle current (at stopped) 6±1mA (4.8V ) 6±1mA(6v)
Running life(at no load) >350000 Turns(4.8V ) >320000 Turns(4.8V )
Temperature drift(at 25°C) ≤5°C(4.8V) ≤7°C(6V)
Mechanical Specification：
Limit angle:200°± 1°
Weight:9 ± 1 g
Connector wire gauge:＃28 PVC
Connector wire length:250 ± 5 mm
Spline:21T
Horn type:Cross,star and bar-type
Excessive play:≤0.5°
Appearance Inspection：
Dimensions:L23xW12.2xH29mm
If there any problem or concern with our product when you get it, you could reach out to us and write message about your issue via Amazon mail:https://www.amazon.com/ss/help/contact/?_encoding=UTF8&marketplaceID=ATVPDKIKX0DER&ref_=v_sp_contact_seller&sellerID=A34CQKEVNF2MJX
Technical Specifications
You might also like
WMYCONGCONG 15 Nylon Control Horns 21x11 mm + Pushrod Connector Linkage Stopper 1.3mm + 1.2 x 210mm Steel Push Rods Parts for RC Airplane Plane
SIKAF MALL RC Servo Tester 3CH Digital Multi ECS Consistency Speed Controler Checker
Hobbypark 25pcs Adjustable Pushrod Connector Linkage Stoppers D1.3mm RC Airplane Plane Parts
EDGELEC 120pcs Breadboard Jumper Wires 10cm 15cm 20cm 30cm 40cm 50cm 100cm Optional Arduino Wire Dupont Cable Assorted Kit Male to Female Male to Male Female to Female Multicolored Ribbon Cables
ARDUINO UNO R3 [A000066]
LAFVIN Nano V3.0, Nano Board ATmega328P 5V 16M Micro-Controller Board Compatible with Arduino IDE (Nano x 3 with USB Cable)
Elegoo EL-CP-004 120pcs Multicolored Dupont Wire 40pin Male to Female, 40pin Male to Male, 40pin Female to Female Breadboard Jumper Wires Ribbon Cables Kit for arduino
XtremeAmazing RC 2200KV Brushless Motor 2212-6 + 30A ESC + Free Mount for RC Plane Helicopter
4PCS Breadboards Kit Include 2PCS 830 Point 2PCS 400 Point Solderless Breadboards for Arduino Proto Shield Distribution Connecting Blocks
Breadboard Solderless Prototype PCB Board - ALLUS BB-009 (3pcs) 400 Pin with 4 Power Rails and Double Sided Tape for Raspberry Pi and Arduino