Midwest Hearth Gas Log Lighter for Wood Burning Fireplace – Universal Burner Pipe Starter with Air/Fuel Mixer, Liquid Propane (LP), 19.5 Inch

INSTALLATION TIPS

✔ A listed gas valve (not included) must be installed upstream of the log lighter.
✔ The log lighter should be located such that the burner ports are horizontal, facing into the fire box, with the air shutter facing out toward the front
✔ Locate lighter to minimize flame impingement on the grate.
✔ Adjust the air shutter to give a sharp blue flame with yellow tips.

LIGHTING/OPERATION

• Make sure chimney flue and glass doors and screens are open.
• Fireplace should be clean of debris, as this could contain hot coals which could cause ignition if not disposed of properly. Ashes should be placed in a metal container with a tight fitting lid. The closed container should be placed on a non-combustible floor, and kept away from other combustible materials until the ashes have cooled.
• Make sure the log lighter gas valve is in the OFF position.
• Stack logs on the fireplace grate allowing an air space between the logs for quick lighting. Wait approximately five minutes before lighting.
• Make sure that shutter on mixing chamber is open to ensure that air and gas is being mixed. Flame should be blue.
• Light the burner by using a long fireplace match or lit paper under the center of the lighter near the burner ports.
• Turn the gas valve ON gradually until burner ignition occurs.
• If burner does not light within 5 seconds, turn valve off and wait 5 minutes before trying to relight.
• When log lighter is burning, close the fireplace screen. Do not close glass doors unless the wood in fireplace has been certified for use with log lighter with doors closed.
• When the wood fire is lit, the log lighter valve should be turned off. Failing to do so will cause wood to burn faster than normal. Remove gas valve key and place in a safe location.