Mangrove Products: Boat Transom Saver TS-Pipe (3-RAM) Black, 2-Pipe

Mangrove Products: Boat Transom Saver TS-Pipe (3-RAM) Black, 2-Pipe

• ✅FITMENT GUIDE-YAMAHA: 4-Stroke/2-Stroke: F115 (2013 and under ONLY, 1-2 Pipes), F150, F175, F200 (2022 and under-Applicable with modification ONLY-see Modification Section-Below, F225, F250, F300, F350 (2-Pipe), XTO 425hp-450hp (2-Pipe), (VMAX/HPDI/SHO): VF150, VF175, VF200, VF225, VF250 (ONLY Applicable with modification-see Modification Section-Below)
• ✅FITMENT GUIDE-Mercury and Suzuki: MERCURY(4-Stroke,2-Stroke) 175hp, 200hp, 225hp, 250hp, 300hp (2 Pipe), ProXS Model: NOT Applicable, Verado (V10+V8+V6) NOT Applicable (Refer to TS-Block), Mercury Racing NOT Applicable (Refer to TS-Block). SUZUKI DF/SS 140hp,150hp,175hp & 200hp (1-Pipe ONLY on Right/Starboard RAM), DF/SS 225hp, 250hp, 300hp, 350 hp (2-Pipe). Stealth Models (Pending Testing). New AP Model: NOT Applicable
• ✅FITMENT GUIDE-Others: TOHATSU MFS/BFT 75 hp-150hp (1-Pipe), 200 hp-250 hp (2-Pipe), HONDA BF 75 hp-225 hp (1-Pipe Right/Starboard Side ONLY) Note: 225 hp can use 2-Pipe but Left/Port Side TS-Pipe will need modification (see modification section-below), 250hp, 300 hp, 350hp (2-Pipe). EVINRUDE E-TECH (H.O. 1st GEN) 140 hp-250 hp (1-2 Pipe) and HO (1st GEN) 300 hp (2-Pipe). Note: Some E-TECH models will need entry hole bored out to clear trim piston tip/head.
• ✅FITMENT CHECK- Check your Trim: Some boats have trim limiters that can cause fitment issues. The first way to check if this is engaged is to check if you are able to engage your maintenance latch. If latch can NOT be set, you have a trim limiter engaged. Next step is to measure from the tip of piston (not the base) to contact point of engine bracket at full tilt up, this MUST be 9.25 inch to clear. If under 9.25 inch, next you will cut remaining excess rubber from TS-Pipe tip to correct desired fitment space. This is critical to ensure correct fitment.
• ✅MODIFICATION SECTION: YAMAHA F-Series 4-Stroke/2-Stroke F150, F175, F200 (Year 2022 and under), and (VMAX, HPDI, SHO) 150hp, 175hp, 200 hp, 225hp, 250 hp (1-Pipe ONLY on Left/Port RAM-Modification Required. Cut 1/8 inch from side of rubber base to slide past hydraulic reservoir). HONDA 225hp if you want to run TS-Pipe on Left/Port RAM, cut 1/8 inch from side of rubber base to slide past hydraulic reservoir).