Malco SH3 18 oz Sheet Metal Setting Hammer – One-Piece Forged I-Beam, Beveled Face & Pein, Leather Grip | HVAC, Roofing & Ductwork

Malco SH3 18 oz Sheet Metal Setting Hammer – One-Piece Forged I-Beam, Beveled Face & Pein, Leather Grip | HVAC, Roofing & Ductwork

• ONE-PIECE FORGED I-BEAM CONSTRUCTION FOR LASTING STRENGTH: Unlike two-piece hammers that can loosen or break at the neck, the SH3's single-forged I-beam head and handle deliver unmatched structural integrity. Built to handle the daily demands of professional sheet metal work, roofing, and HVAC duct installation.
• INDIVIDUALLY HARDENED & TEMPERED HEAD SECTIONS: Each section of the hammer is independently hardened and tempered, giving you a precisely balanced 18 oz striking weight with the resilience to absorb repeated impact without deforming.
• FULL-POLISHED BEVELED FACE & PEIN, CORROSION RESISTANT: The highly polished, beveled 7/8-inch face and pein resist rust and corrosion even in outdoor or high-humidity job site conditions. The smooth finish reduces marring on sheet metal surfaces so your work stays clean and professional.
• LEATHER GRIP THAT CONFORMS TO YOUR HAND OVER TIME: Protected with a durable lacquer coating, the SH3's leather grip forms a custom fit to your hand the more you use it. Natural leather absorbs vibration and provides a sure, comfortable hold, even during extended overhead or repetitive-strike work.
• THE INDUSTRY STANDARD: Trusted by professional roofers, HVAC technicians, and sheet metal workers across North America. At 11-3/4 inches overall length and perfectly balanced at 18 oz., the SH3 is the setting hammer other brands are measured against.