Malco SH3V 18 oz Sheet Metal Setting Hammer – VINYL GRIP | One-Piece Forged I-Beam | Beveled Face & Pein | Recoil-Minimizing Molded Grip | HVAC, Roofing & Sheet Metal | Made in USA

Malco SH3V 18 oz Sheet Metal Setting Hammer – VINYL GRIP | One-Piece Forged I-Beam | Beveled Face & Pein | Recoil-Minimizing Molded Grip | HVAC, Roofing & Sheet Metal | Made in USA

• RECOIL-MINIMIZING, VINYL GRIP, NON-SLIP, AND CONSISTENT FROM THE FIRST STRIKE: The SH3V's molded-on vinyl grip is comfortable and non-slip from day one. The vinyl construction absorbs recoil on every strike, keeping your hand from fatiguing through a long day of setting sheet metal seams, driving cleats, or working ductwork on a commercial job. It doesn't change over time. It doesn't require break-in. What you feel the first time is what you get every time.
• ONE-PIECE FORGED I-BEAM CONSTRUCTION: The SH3V is forged as a single piece in an I-beam profile, so the head and handle are structurally the same component. There's no separate handle to loosen, no joint between head and neck to crack under repeated impact. Each section is individually hardened and tempered for strength and resilience, giving you a precisely balanced 18 oz striking weight that holds up under the daily demands of professional sheet metal work.
• FULLY POLISHED CORROSION RESISTANT BEVELED FACE & PEIN, WON'T MAR SHEET METAL SURFACES: The 7/8-inch beveled face and matching pein are fully polished and corrosion resistant, holding up in outdoor, humid, and high-use environments without rusting or pitting. The polished finish reduces the risk of marring painted or coated sheet metal surfaces on contact an important feature for finished roofing panels, coated fascia, and galvanized ductwork where surface damage leads to rework or callbacks.
• BUILT FOR HVAC TECHNICIANS, SHEET METAL WORKERS & ROOFERS WHO HAMMER EVERY DAY: The SH3V is the right choice for anyone who wants consistent grip performance in any weather or glove situation without waiting for leather to break in. At 11-3/4 inches overall and 18 oz, the balance is right for setting standing seam panels, driving cleats, working duct runs, and general sheet metal fabrication. It goes in the tool belt or bag and comes out ready to work, every job, every season.
• MADE IN USA: Malco's SH3 line has been in daily use by HVAC and sheet metal tradespeople for decades. The construction that made the leather version a career tool carries over to the vinyl grip model with the same forged I-beam body, same hardened and tempered head sections, same corrosion-resistant finish. Prefer the leather version? The SH3 with leather grip is also available.