MIXC Quick-Connect Drip Irrigation Emitters for 1/4" Drip Irrigation Tubing

MIXC Quick-Connect Drip Irrigation Emitters for 1/4" Drip Irrigation Tubing

• 【Push-to-Fit Quick Connection】These Push-to-Fit Drip Irrigation Emitters press directly into compatible 1/4-inch tubing without heating the hose or adding a separate barb fitting. Push the tube fully into the connector and pull gently to confirm it is seated before turning on the water.
• 【Adjustable Stream-Spray Watering】Rotate the emitter head to adjust the 360° stream pattern, increase or reduce output, or shut off an individual watering point. The adjustable pattern can be directed around vegetables, shrubs, flower beds, greenhouse rows, pots, and landscape plants.
• 【Up to 25 GPH and 10-Foot Coverage】Each emitter is rated for output up to 25 gallons per hour and a spray diameter up to 10 feet under suitable pressure. Actual flow and coverage vary with inlet pressure, tubing length, elevation, and the number of drip irrigation parts operating on the same line.
• 【Sized for Compatible 1/4-Inch Tubing】Designed for 1/4-inch drip irrigation tubing with an outside diameter no greater than 0.27 inch. Check the actual outside diameter of your polyethylene, vinyl, or PVC line before ordering; tubing labeled 1/4 inch can vary by manufacturer.
• 【5.2-Inch Stake and Serviceable Head】The sturdy 5.2-inch stake positions the stream emitter near the plant, while the detachable head opens for rinsing and routine cleaning. Flush the irrigation line before installation and inspect emitters periodically where hard water or sediment may cause buildup.