Left Side Armory Saddle Hip Saver Bridge Spreader for Tree Saddle Hunting, Holds Bridge Legs 4.53 in. (115 mm) Apart at the Carabiner, Stops Hip Pinch, Rope-Retention Ears, Nylon 12, Made in USA

Left Side Armory Saddle Hip Saver Bridge Spreader for Tree Saddle Hunting, Holds Bridge Legs 4.53 in. (115 mm) Apart at the Carabiner, Stops Hip Pinch, Rope-Retention Ears, Nylon 12, Made in USA

• Hold Both Bridge Legs 4.53 IN. Apart: The Hip Saver sits up at your carabiner and holds the two legs of your bridge 4.53 in. (115 mm) apart, so they stop converging and pinching in on your hips as you hang. That is a measured spread width, not a vague promise about pressure. It is the difference between watching the clock on a long sit and staying put until last light.
• Rope-Retention Ears Keep It On The Rope: Retention ears at the top capture the bridge rope and grip the spreader to it. When you stand up, lean in, or let slack into the bridge, the Hip Saver stays seated instead of sliding loose and falling to the ground below your platform. You can set it once at the truck and stop thinking about it for the rest of the sit.
• Slick Finished Channel So The Rope Glides and the Setup Stays Quiet: The rope channel carries a post-process surface finish that leaves it smooth and low friction. Your bridge legs slide through as you shift your weight, turn to face the tree, or lean out for a shot, instead of gripping and locking you into one position. That same finished surface cuts the click and squeak where your carabiner rides against the part.
• Fits and Saddle: The Hip Saver clips in at the junction between your tether and your bridge rope, a standard interface on every saddle setup, so it does not care what brand you hunt. It rides above you at the carabiner and never contacts your body. As for whether it will let go on you at height, your rope stays captured inside your carabiner the whole time, so the Hip Saver is not what holds you in the tree and could not drop you if it gave out.
• Commercial Grade, Made In Michigan: Every part is produced on commercial-grade equipment in Nylon 12, black, so they come out the same part to part. It weighs 1.59 oz (45.2 g) and measures 5.00 x 2.05 x 0.59 in. (127 x 52 x 15 mm), with a rope channel about 0.67 in. (17 mm) deep and an opening at the ears of about 0.51 in. (13 mm), so measure your own bridge rope before you order. Made in Coopersville, West Michigan, USA and backed by a Limited Lifetime warranty.