LeafsOut 5” WIDE, DIY Micro Mesh Rain Gutter Guard System – 100' LONG, Stainless Steel

The LeafsOut Gutter Protection System consists of three main components: a front anodized aluminum drip edge; a stainless steel V-Bend filter mesh; and a black water siphon control strip on the bottom side of the mesh that literally pulls water into the rain gutter. LeafsOut gutter guard can be installed on various gutter types such as Ogee, half round, fascia, curved and box. It can also be installed on various types of roofs such as asphalt shingle, wood shake, flat tile, Spanish tile and stone coated steel. Installation: The front aluminum edge has a stop that will push up against the inside front edge of the rain gutter and a rest that will fit on top of the front edge and can be screwed on with included self tapping screws. The back edge slides in between the roof and the roof shingles. We recommend the micro mesh to be at an angle between 5 and 15 degrees. A higher angle may result in water running of the mesh instead of into the gutter. If the angle is steep the back of the mesh can be bent and attached to the fascia board.