Leadshine DM556 2-Phase CNC Digital Microstep Stepper Motor Driver 2.10-5.60A 20-50VDC for NEMA 14,17,23 Stepper Motors

Overview
By implementing the latest DSP current control technology, Leadshine DM556 is a high performance 2-phase digital stepper drive.
It takes step & direction or CW/CCW control commands, and is very simple to implement in OEM applications.


Electrial Sepcifications:
*Control Mode: Step & Direction
*Max Input Frequency: 200KHz
*Input Voltage Range: 20 - 50 VDC
*Suggested Power Supply Voltage Range: 24-48 VDC
*Software Cofig. Resolution Range: 200 - 102,400 (increased by 200)
* of DIP Switch Resolution Configurations: 16
*DIP Switch Resolution Setings: 200, 400, 800, 1600, 3200, 6400, 12800, 25600, 1000, 2000, 4000, 5000, 8000, 10000, 20000, 25000
*Software Cofig Current Range: 0.5 - 5.60 A (increased by 0.1 A)
* of DIP Switch Current Configurations: 7
*DIP Switch Current Configurations: 2.1A, 2.7A, 3.2A, 3.8A, 4.3A, 4.9A, 5.6A
*Logic Current Range: 7-16mA (10mA typical)
*Logic Voltage Range: 4-5 VDC for pulse active high (default) , or 0-0.5V for pulse active low
*Communication Type: RS232
*Pulse enabled at: Rising edge
*Idle Current Percentage: 50 %
*Software Config. Idle Current Percentage: 0-100%
* of Digital Inputs: 3
* Step Width: 2,500 ns
*Minimal Direction Setup Time: 5,000 ns
*Protection: Over current; over voltage; phase error
*Isolation Resistance: 500M Ohm
*Environment: Avoid dust, oil fog and corrosive gases
*Ambient Temporature: 0-50°C
*Humidity: 40-95% RH
*Operating Temporature: 0-70°C
*Vibration: 5.9 m/s2 Max
*Storage Temporature: -20-65°C