JDM Red Bumper Quick Release Fastener Kit for Front & Rear Bumpers

JDM Red Bumper Quick Release Fastener Kit for Front & Rear Bumpers

• Installation: Mark and drill your mounting points, bolt each CNC aluminum tab through with the included M6 hardware using a hex wrench, then loop the O-ring between the bumper and fender tabs and pull it to release in seconds.
• What's Included: 4x CNC-machined aluminum tabs (stronger than stock plastic), 4x M6 stainless steel bolts, 4x lock nuts, 4x washers, and 8x NBR O-rings with 6 held in reserve as spares.
• Drilling Required: This is a bolt-and-O-ring system, not a no-drill or adhesive kit. Drilling is typically needed depending on your bumper material, so look elsewhere if you need a fully reversible, hole-free mount.
• O-Ring Durability: Nitrile butadiene rubber O-rings stretch to hold firm tension between the tabs and loop off cleanly when you need the bumper free. 6 spares are included since this is the one part that wears with sun and road exposure over time.
• Broken Bumper Clip Fix: A snapped or brittle factory bumper clip is one of the most common issues on older, high-mileage cars. This kit costs a fraction of OEM replacement clips or a body shop visit, and skips zip ties or tape entirely.