Imdinnogo BCZAMD PT1000-550BW Temperature Sensor Probe for CR-10 Plating Copper/3D Volcan/ V6 Brass 3D Printer Heater Block Thermistor Sensor Probe Resistant to high Temperature 1.5M/ 59 inch

Imdinnogo BCZAMD PT1000-550BW Temperature Sensor Probe for CR-10 Plating Copper/3D Volcan/ V6 Brass 3D Printer Heater Block Thermistor Sensor Probe Resistant to high Temperature 1.5M/ 59 inch

• Tips：It is truly PT1000, not DS18B20, please reference the pictures. The temperature sensor probe is equipped cord 1.5 meter long, which is convenient connection for 3D printer, use for 3D priter hot end Cr-10 plating copper/V6 brass/V6 aluminum/Volcanic heating block
• Electrical design:The resistor probe line is long service life, resistant to high temperature, two wire system.
• High temperature wire Silver plated, the platinum resistor is waterproof. No issues with Klippe, and EBB36 CAN board
• Size: 3mm x 15mm, wire length 1.5meter. Probe Temperature range:-40 °C ~ 500 °C.
• Kindly Tips: About this PT1000 temperature sensor, it is no issues to Probe Temperature range:-40 °C ~ 500 °C. But it is a little complicated, before ordering, please know which firmware( Marlin/Klippe/RRF) does your board support, whether it is open source or not. Please reference the install information for the left pictures.