Hot Racing RVO288E06 Steel Drive Shaft 4wd

Hot Racing dual slider CV joint axle driveshafts for the front or rear of the NEW Traxxas 1/10th scale E-Revo, E-Maxx, Revo 3.3, T-Maxx 3.3, and Summit. These shafts are compatible with vehicles that use the Traxxas 5451X axle shafts. Please confirm that the vehicle uses these shafts before ordering. FEATURES: - Heavy duty CNC machined #45 hardened carbon steel construction- Replaces factory plastic front or rear drive axles- Blue anodized aluminum pin capture rings with rubber o-rings to prevent movement- Design eliminates CV pin setscrew- Steel is finished blackYOU WILL RECEIVE: - Two (2) axle assemblies- Two (2) M4x2.5x13mm screw pinsREQUIREMENTS: - Installation at rear drive assembly- Recommended to maintain CV joint and shaft spline with grease- Recommended to use a removable-type locking adhesive on screws threading into/onto metalSPECIFICATIONS: - Travel: 22mm- Overall collapsed length: 166mm (6.5in)- Overall extended length: 188mm (7.4in)- Wheel pin to outdrive pin collapsed length: 147mm (5.8in)- Wheel pin to outdrive pin extended length: 169mm (6.7in)COMMENTS: - For over 16.8 volt power best use RVO288RC or RVO288V06- Replaces factory plastic Traxxas 5451X axle driveshaft assembly- Replacement/spare drive hubs are Hot Racing- Replacement/spare slider shafts are Hot Racing- Replacement/spare CV rebuild kit is Hot Racing RRVO0288E06- Replacement/spare outer axle stub is Hot Racing RCV15AAdescription revised by: PP January 7, 2017