60KG Digital Servo Motor High Torque PWM Servo, Waterproof Full Metal Gear Steering Servo for Robotic Arms, DIY Robot Making, Large RC Car, Control Angle 180°
Product Description
60KG Digital Servo Motor High Torque PWM Servo, Waterproof Full Metal Gear Steering Servo for Robotic Arms, DIY Robot Making, Large RC Car, Control Angle 180°
- 60kg-180° digital servo motor is perfect for robot-making and large RC cars. (The size is bigger than general servos. May NOT be good for RC cars). If you are looking for a wonderful servo for your RC car, our recommended selection is 35kg > 20kg > 25kg.
- 60kg large torque. 58 kg·cm (805 oz·in) @ 6.0V; 65 kg·cm (902 oz·in) @ 7.4V; 70 kg·cm (972 oz·in) @ 8.4V
- 180 degree rotation. Controllable angle range from 0 to 180 degrees, Excellent linearity, precision control. Can be rotated within 360 degrees when power off
- Using high-precision potentiometer with new design. Accuracy and linearity have been greatly improved! Accurate movement can satisfy the needs of making robots.
- Aluminium Case. Enhance the heat dissipation, ensure that servo motor can work well
- Full metal gear. it's better for accuracy, service life has been greatly increased
Mechanical Specification:
Weight: 158g(5.57 OZ)
Dimension: 65*30*48mm(2.56*1.18*1.9 inch)
Gear ratio: 279
Connector wire: 300mm(11.8 inch)
Electrical Specification:
Working Voltage: 6-8.4V
Operating Speed (at no load): 0.17 sec/60°@6V; 0.15sec/60°@7.4V; 0.13sec/60°@8.4V
Stall Torque(at locked): 58 kg·cm (805 oz·in) @ 6.0V; 65 kg·cm (902 oz·in) @ 7.4V; 70 kg·cm (972 oz·in) @ 8.4V
Control Specification:
Control Method: PWM
Pulse Width: 500~2500µsec
Neutral position: 1500µsec
Dead band width: 3 µsec
Operating frequency: 50-330Hz
Please make sure that the pulse width of the controller you are using conform to our specifications, otherwise the servo can't turn up to claimed degrees
Wire Layout:
Red Wire: +
Black Wire: GND
White Wire: PWM/Signal
Package Contents:
1 x Digital servo
1 x Servo horn kit(as shown in the image)
Tips:
1. Please use Li-Po battery to power the servo, Do Not use dry battery, otherwise the servo will move slowly or not at all(our servo has higher torque, so it also need more powerful power to drive itself).
2. Please use short and thick power cord, Do Not use Dupont cord
3. Our servo can be controlled by Arduino, please refer to the Arduino library.
If you have any questions, please feel free to contact us at [email protected], we will help you as soon as possible
Technical Specifications
You might also like
LewanSoul LD-25MG Full Metal Gear Standard Digital Servo with 25kg High Torque, Aluminium Case for Robot RC Car(Control Angle 180)
Tenergy NiMH Receiver RX Battery with Hitec Connectors 6V 2000mAh High Capacity Rechargeable Battery Pack for RC Airplanes/RC Aircrafts and More
ZOSKAY Waterproof High Torque Metal Gear Standard Digital Servo 25KG/0.13S 6.8V for 1/8 1/10 RC Cars(Control Angle 180)