HiLetgo 12V 1 Channel Relay Module with Optocoupler Isolation Support High or Low Level Trigger
Product Description
HiLetgo 12V 1 Channel Relay Module with Optocoupler Isolation Support High or Low Level Trigger
- Module uses genuine high quality relay, normally open interface maximum load: AC 250V / 10A, DC 30V / 10A
- Using optocoupler chip isolation, strong drive capability, stable performance; trigger current 5mA
- Module can be set by jumper high or low trigger
- Fault-tolerant design, even if the control line is broken, the relay will not move
- The interface design of human nature, all interfaces are available through a direct connection terminal leads, very convenient
Module description:
Module Size: 50mm * 26mm * 18.5mm (L * W * H)
With four fixed bolt holes, holes 3.1mm, spacing 44.5mm * 20.5mm
Power Indicator (green), Relay Status Indicator (red)
Interface:
Input:
VCC: Relay power supply +
GND: Relay power supply -
IN: Signal trigger input (High or Low Level Signal, select via jumper)
Output:
NO: Relay normally open.
COM: Relay Common Pin
NC: Relay normally closed.
Package Included：
1*12V 1 Channel Relay Module With Optocoupler Isolation
How to provide an auto shut-down for Prusa i3 Mk2S?
1. Wired it in parallel with the power switch.
2. Use the hotend fan power as the trigger.
3. When you run a long print ,start the printer and when the hotend fan turns on (at about 50C) you can turn off the power switch.
4.The printer continues to run until the print is finished and the hotend cools below 50C. At that point the relay is no longer powered and the printer shuts itself off.
Technical Specifications
You might also like
DZS Elec 12V 4 Channel High / Low Level Trigger with Optical Isolation Relay Module Fault Tolerant Design Load AC 0-250V/10A DC 0-30V/10A Circuit Switch Board
Tolako 5v Relay Module for Arduino ARM PIC AVR MCU 5V Indicator Light LED 1 Channel Relay Module Works with Official Arduino Boards
QLOUNI 620Pcs 2.54mm Pitch JST SM 1 2 3 4 5 6 Pin Housing Connector Dupont Male Female Crimp Pins Adaptor Assortment Kit
DZS Elec 12V 2 Channel High / Low Level Trigger with Optical Isolation Relay Module Fault Tolerant Design Load AC 0-250V/10A DC 0-30V/10A Circuit Switch Board
8-Channel DC 12V 8CH Relay Module with Optocoupler H/L Level Trigger for Arduino
SMAKN® SRD-12VDC-SL-C 1 Channel DC 12V High/Low Level Power Relay Module Board
Ogrmar SSR-40DD 40A Solid State Relay DC 3-32V DC 5-200V + Heat Sink (SSR-40 DD, Grey and Black)
HiLetgo 12V 8 Channel Relay Module With Optocoupler High And Low Level Trigger
3PCS Mini Solderless Breadboard,400 Ties Clear Circuit PCB Board Kit for Proto Shield Circboard Prototyping
DAOKI 5PCS 5V One 1 Channel Relay Module Board Shield with optocoupler Support High and Low Level Trigger