HYS NMO Antenna Mount 3/8" to 3/4" Hole W/13ft RG58U Coaxial Cable to PL259

HYS NMO Antenna Mount 3/8" to 3/4" Hole W/13ft RG58U Coaxial Cable to PL259

• UNIVERSAL NMO MOUNT FOR MOBILE RADIOS: Standard NMO connector fits all NMO VHF/UHF/CB/HF/GMRS mobile whip antennas. PL259 UHF male plug connects to SO239 UHF female radio input on mobile transceivers, for Motorola, Kenwood, Icom, Yaesu, Vertex, Midland, Cobra, Uniden, Retevis, Wouxun, Anytone, TYT, Hytera, Alinco and Baofeng handhelds with SO239 adapter. For NMO antennas from Tram, Browning, Larsen, PCTEL. Antenna sold separately; this is the mount base and cable assembly.
• FLEXIBLE 3/8 TO 3/4 INCH HOLE MOUNT: The through-hole NMO mount requires drilling a small hole (3/8 to 3/4 inch / 9.5-19mm) through the vehicle surface for a permanent, professional installation. This is the best choice for an extremely rugged and low-profile antenna mounting compared to magnetic or clip-on mounts. Install on roof for best ground plane performance, or on trunk, fender, or hood. The low-profile NMO base sits flush with the vehicle surface for a clean, factory-quality appearance.
• 13FT / 4M RG58 LOW-LOSS COAXIAL CABLE: Factory pre-assembled with 13 feet (approximately 4 meters) of RG58 low-loss coaxial cable, providing ample length to route from the antenna mounting point through the vehicle interior to your mobile radio. The stranded copper center conductor ensures high-quality signal transmission with minimal loss. The PL259 UHF male plug at the radio end fits standard SO239 UHF female inputs on most mobile transceivers, ham radios, and GMRS radios.
• COAX SHIELD GROUNDING FOR CLEAR SIGNAL: The coax cable shield must be properly grounded to the radio chassis ground at the radio end to reduce interference and ensure clear signal. The NMO base design facilitates this grounding connection between coax shield and vehicle ground plane. Proper shield grounding prevents RF noise and ground loops, providing professional-grade signal clarity for reliable mobile communications in any vehicle or environment.
• PERFECT FOR ALL VEHICLES AND USES: Fits car, truck, SUV, sedan, pickup, semi truck, Jeep, van, RV, taxi, or fleet vehicles. Ideal for ham radio operators, GMRS users, CB enthusiasts, overland adventurers, police, emergency services, commercial fleets, delivery drivers, security, and off-road users. The 13ft cable routes cleanly from roof or trunk to your radio under dash, in center console, or under seat. Professional-grade mobile radio installation solution.
• DURABLE CONSTRUCTION AND RISK-FREE PURCHASE: Built with stainless steel and corrosion-resistant hardware for years of reliable service in demanding outdoor conditions. The low-profile NMO base maintains a clean, factory-installed appearance on your vehicle. Factory pre-assembled and ready to install - no soldering, crimping, or connector assembly required.