HX AURIZE Fusible Interfacing Dots for Snaps & Grommets, 100 Pcs 1.2 in

HX AURIZE Fusible Interfacing Dots for Snaps & Grommets, 100 Pcs 1.2 in

• IRON FIRST, THEN PUNCH & INSTALL: Place the dot on the back side of the fabric with the shiny adhesive side touching the fabric. Press, let it cool, then punch the reinforced center and set your snap, grommet, or eyelet hardware.
• SOFT HIGH-DENSITY WOVEN SUPPORT: The dot is dense for stronger backing, but still soft and low-profile on fabric. It is used on the reverse side, so the front of your project stays clean and neat.
• STOP SNAPS FROM RIPPING FABRIC: Snaps, grommets, and eyelets can rip through thin, stretchy, knit, or weakened fabric when pulled. This backing dot adds a hidden support layer to help reduce tearing around the hole.
• 100 PRE-CUT DOTS SAVE TIME: You could cut circles from fusible interfacing yourself, but these ready-made 20mm or 30mm dots save trimming time and give you a consistent shape for hardware installation and small repairs.
• WASHABLE, BUT TEST FIRST: Chosen for regular washing and tumble drying when applied correctly. Not every fabric is suitable for iron-on adhesive, so test heat, pressure, and adhesion on a scrap piece first.