Glass Cutters for Stained Glass, Drill Bits for Drilling Holes in Glass, Bottles & Blocks. Stained Glass Cutter, Oil and Diamond Tip Drill Bits for Wine Bottles with DIY Instructions & Online Videos

Glass Cutters for Stained Glass, Drill Bits for Drilling Holes in Glass, Bottles & Blocks. Stained Glass Cutter, Oil and Diamond Tip Drill Bits for Wine Bottles with DIY Instructions & Online Videos

• STAINED GLASS CUTTING KIT - Watch Stained Glass Cutting Video Read Instructions Download User Guide. You Must Soak Stain Glass Cutter Tool Wheel in Glass Cutting Oil, Run Wheel Up And Down A Board To Check Wheel is Turning Easy So It Can Score Stained Glass Sheet Evenly, If Glass Cutter Blade Stops It Will Stick and Drag Across Glass And That Stops it Working. Scoring Wheel Must Be Oiled Every Cut. Practice On Stained Glass Sheet First to Make Sure You Have Got Glass Scoring and Break Technique.
• HOLD STAINED GLASS CUTTER TOOL – Handles Of Glass Cutter Tool Are Only For Squeezing Glass To Break, Do Not Hold Stained Glass Cutter by Handles When Scoring. Hold Close To Wheel for Control And To Put Pressure on Blade. Technique is to Create Small V In Surface Of Glass Sheet. Scoring Way Too Hard Or Without Oiling Wheel Leaves Thick Groove And Dusty Line that Will Not Break Correct Instead Of A Shallow V, The Perfect Stained Glass Score Must Be Just Firm Enough To Leave the V Score in Glass.
• CUT CURVES IN STAINED GLASS – Even Wavy Lines Are Possible If Stained Glass Tool Is Held Correctly And Instructions Followed. Draw Shape On Smoothest Side of Glass And Follow The Line With Stain Glass Cutter Tool Wheel. The Stained Glass Cutters Tool Must Be Held Perpendicular, Do Not Lean Cutter Over or It Will Slide Sideways And Glass Cutter Will Not Cut V In Stained Glass. Smooth Curves Are Ok Sharp Angles Are Not. Deep Curves Will Need To Squeeze The Score On Stained Glass From Both Sides.
• RUNNING PLIERS STAINED GLASS – Place Stained Glass Cutting Tools Breaker Dead Center Over Score Line, Lift Glass Sheet, Squeeze Handles Ever So Gently At End. If Gap Is Too Big Fold Breaker Forward By Pivoting It To Make Gap In Between Pliers Small, This Allows You To Squeeze Very Thin Strips of Stained Glass. Over Squeezing Will Chip Edges. For Radius Cuts Angle Breaker Towards Score Line Dead Center. Cutting Small Strips Is Possible Within Laws Of Physics. Watch Videos If Any Of This Unclear.
• GLASS DRILL BIT – 3/16” ¼” ½” Drill Bit For Glass Drill Bit For Bottles, These Glass Cutting Drill Bits For Drilling Holes In Glass Are To Be Used Wet, Glass Drilling Bits Will Also Drill Holes In Porcelain Tile So Not Just Drill Bits For Glass Sheet Also A Drill Bit For Glass Bottles And Drilling Holes In Glass Blocks For Making Wine Bottle Lamps And Lights. The ½” Glass Drill Bit is the Perfect size for Tree Lights to Push Through. On Flat Surfaces the Guides can be used To Hold Bits Straight