GTJ White Frosted Window Privacy Film, Static Cling No Glue, 34.7 x 78.7 in

GTJ White Frosted Window Privacy Film, Static Cling No Glue, 34.7 x 78.7 in

• Solid White Frosted Privacy: The entire film has a solid white matte finish with a fine-grain frosted texture. It blurs shapes and details from either side while still allowing soft daylight through. Privacy may vary with lighting and viewing distance.
• Static Cling, No Glue: Apply the window film to clean, smooth glass with plenty of water or water mixed with a few drops of mild dish soap. It can be repositioned while wet, removed without sticky residue, and reused when the cling side is kept clean and stored flat.
• Remove the Clear Liner First: Use both peel-assist stickers at the same corner. Place one sticker on the window film and the other on the clear liner, press both firmly, then pull in opposite directions to separate the film from the liner. If needed, reposition the stickers or try another corner.
• Wet Installation, Tools Included: Clean the glass, spray the entire surface thoroughly, remove the liner completely, and place the exposed cling side against the wet glass. Slide the film into position, push out excess water and air with the squeegee, then trim the edges. A spray bottle, squeegee, utility knife, and peel-assist stickers are included.
• Smooth, Flat Glass Only: Use only on clean, smooth, flat glass. Do not apply to textured, rough, uneven, pre-frosted, cracked, or curved glass. The film may not cling properly if the glass is too dry, the clear liner remains attached, or the wrong side faces the glass. It softens light and glare but does not block all light.