GTJ Frosted Glass Window Privacy Film, Static Cling No Glue, 34.7 x 78.7 in

GTJ Frosted Glass Window Privacy Film, Static Cling No Glue, 34.7 x 78.7 in

• Frosted Privacy from Either Side: This is not a one-way mirror film. The translucent matte finish softens views from both sides at normal viewing distances while still allowing daylight through. At close range, outlines may remain visible, and privacy can vary with lighting.
• Static Cling, No Glue: Apply the window film to clean, smooth glass with plenty of water or water mixed with a few drops of mild dish soap. It can be adjusted while wet, removed without sticky residue, and reused when the cling side is kept clean and stored flat.
• Remove the Clear Liner First: Use both peel-assist stickers at the same corner. Place one sticker on the window film and the other on the clear liner, press both firmly, then pull in opposite directions to separate the film from the liner. Reposition the stickers or try another corner if the liner is difficult to lift.
• Wet Installation, Tools Included: Clean the glass, spray plenty of water over the surface, remove the liner completely, and place the exposed cling side against the wet glass. Slide the film into position, push out excess water and air with the squeegee, then trim the edges. A spray bottle, squeegee, utility knife, and peel-assist stickers are included.
• Smooth, Flat Glass Only: Apply only to clean, smooth, flat glass. Do not use on textured, rough, uneven, pre-frosted, cracked, or curved glass. The film may not cling properly if the glass is too dry, the liner remains attached, or the wrong side faces the glass. It softens light and glare but is not a blackout film.