Fulight Type B & 12-30V DC LED F15T8 Tube Light, 18-Inch, Daylight 6000K
Product Description
Fulight Type B & 12-30V DC LED F15T8 Tube Light, 18-Inch, Daylight 6000K
- Type B Non-Plug-and-Play Installation: You must disconnect ballast and do fixture rewiring if you had fluorescent bulb in your fixture. The installation manual is attached as the 2nd photo at the left upper corner of this product page. Please review it before buying
- RV and Marine Lighting Application: To replace F15T8 and F15T12 fluorescent tube with Instant-On Daylight 6000K under the power supply of 12V or 24V DC. Cannot be used in 110/120V AC home fixtures
- Actual Length Measurement: Measures 17-3/4 inches from pin to pin. Please measure your old bulb or light fixture to confirm the fitness before buying
- Rotatable Design Feature: Light forwarding angle can be adjusted by plus or minus 90 degrees to fit any light fixture
- Energy Efficient Performance: Low heat operation with energy saving of more than 50 percent electricity consumption compared to traditional fluorescent tubes
- Daylight Color Temperature: Provides bright 6000K daylight white illumination for enhanced visibility and clarity in your RV or marine applications
- Wide Voltage Compatibility: Works with 12-30V DC power supply systems, making it versatile for various low voltage applications in recreational vehicles and boats
****WARNIN I: It's a 12-30V DC LED tube light! NEVER use it with AC 110/120VAC source unless you have an AC-DC converter to achieve 12-30V DC power. Please check your fixture voltage before buying****
****WARNING II: Actual Length 17-3/4" pin to pin! Please measure your old bulb to confirm the fitness. If your fluorescent bulb is fully 18" pin to pin, it doesn't fit! ****
****Installation: Fixture Rewiring is Easy but Required! The installation manual is the 2nd photo at the upper left corner of this product page. The manual will also be enclosed inside the package shipped to you. Please ensure to follow the manual to install this LED light! It must be directly wired to your 12-30V DC power from the two input ends on both sides without the use of any electronic ballast or starter. Ask help from an electrician if you don't have enough electrical basics! ****




