Fluke TP88 Rigid Back Probe Pin Set, 2" Length
Product Description
Fluke TP88 Rigid Back Probe Pin Set, 2" Length
- The Fluke slim-reach test probe is designed for probing closely spaced or recessed terminals
- Hard stainless steel probe tips
- Flat blade design to hold securely in blade type electrical wall sockets
- CAT IV 600V, CAT III 1000V, 10 A rating, UL listed
- 1 Year
Rigid back probe pin set. Better than a test probe alone - these two inch long rigid back probe pins easily pass between the weather pack seal and wire. A sharp point ensures good contact to the electrical connector, and the pin's insulation protects it from shorting to other wires. Slides onto test probes measuring 2mm (0.08 inches). Tested to 60V DC.
Technical Specifications
You might also like
Fluke T5-RLS Replacement Test Lead Set
Fluke AC285 SureGrip Alligator Clips
Fluke AC175 Threaded Slide-on Alligator Clip Set with Flexible Boots
Fluke TLK-225 SureGrip Master Accessory Set
Fluke TL75 Hard Point Test Lead Set
Fluke AC220 SureGrip Alligator Clips
Fluke 8845A-EFPT Extended Fine Point Tip Adapter Set, Red/Black
Test Leads, 59 In. L, Black/Red, PR
Multimeter Hanging Kit with Clip and Magnetic Hanger, works with Fluke Meters
Aenllosi Hard Case for Fluke T5-1000/Fluke T5600 Electrical Voltage, Continuity and Current Tester