Filament Cutter Sensor for Creality Sparkx-i7: Cutting Transfer Adapter Board Detection PCB Module for Sparkx i7 3D Printer Printhead Replacement Parts

Filament Cutter Sensor for Creality Sparkx-i7: Cutting Transfer Adapter Board Detection PCB Module for Sparkx i7 3D Printer Printhead Replacement Parts

• A necessary accessory on hand: this module determines whether the cutter has successfully cut the filament, whether it has rebounded properly, and whether it is jammed or not in place is a key safety and status feedback module for the i7 multi-color filament change / automatic filament refill.
• This cutter detection module contains a hall sensor - cutter-magnet - mainboard logic.
• Common failure alerts: cutter stuck - incomplete rebound, clean the magnet/ sensor, and check for filament clogging; Cutter not reset - same as above, possible causes include a dull blade or excessive resistance.
• Cutter replacement recommended: significant wear or unstable cutting performance.
• Compatible motherboard: for Sparkx i7 main control board and CFS multi-color expansion board. Recommend DC 3.3V, prohibited from using 5V. Install guide please follow the official-wiki, search keywords: for sparkx i7 replacement filament cutter sensor.