R632A-JFF Integral Two Stage Propane Regulator – LP Gas Pressure Control for Tank, 9"-13" WC, POL x 3/4" FNPT, 850,000 BTU, Residential Regulators
Product Description
R632A-JFF Integral Two Stage Propane Regulator – LP Gas Pressure Control for Tank, 9"-13" WC, POL x 3/4" FNPT, 850,000 BTU, Residential Regulators
- Integral 2 Stage Pressure Control: Combines first and second stage regulation in one regulator, reducing propane tank pressure to a 9”-13” WC spring range, helping gas equipment maintain steady output without surges, drops, or uneven performance
- Simplified Installation With One Regulator: Combines first and second stage regulation to reduce installation time, minimize connection points, and streamline LP gas system setup for home, camper, and RV propane tank applications
- High Capacity For Residential Demand: Handles up to 850,000 BTU and supports up to 250 psig inlet pressure, helping prevent pressure drop and keep propane gas equipment running strong during peak demand across house and whole system use
- POL x 3/4 Inch FNPT Connection Fit: POL inlet and standard 3/4 inch FNPT outlet integrate with common tank, hose, and kit configurations, helping simplify replacement and ensure proper fit across LPG equipment systems
- UL-Listed With Dual Vent Protection: UL-listed regulator with first stage 7/16-24 inverted flare vent and second stage 3/4 inch screened vent helps manage excess PSI and protect downstream equipment for safer long-term operation
The Type R632A is an Underwriters Laboratories (UL) listed regulator designed for Two-Stage LP-Gas systems. The unit is designed to reduce the tank pressure through an integral two-stage system to 11 inches w.c. / 27.4 mbar. The first-stage screened drip-lip vent is oriented downward and the second-stage vent is oriented over the outlet as standard.
!!! WARNING !!! Failure to follow these instructions or to properly install and maintain this equipment could result in an explosion and/or fire causing property damage and personal injury or death. Fisher equipment must be installed, operated and maintained in accordance with Federal, state and local codes and Fisher instructions. The installation in most States must also comply with NFPA no. 54 and 58 standards. Only Personnel trained in the proper procedures, codes, standards and regulations of the LP-gas industry should install and service this equipment.
BUYER AGREES THAT RESPONSIBILITY FOR PROPER SELECTION, INSTALLATION, USE AND MAINTENANCE OF ANY PRODUCT REMAINS SOLELY WITH THE PURCHASER AND END-USER. BUYER AGREES TO COMPLY WITH THE ABOVE WARNING AND ALL INSTRUCTION MANUALS, BULLETINS AND INSTALLATION GUIDES ASSOCIATED WITH THIS PRODUCT.
Technical Specifications
You might also like
Mr. Heater 2-Tank Hook-Up Kit with Tee and 30-Inch Hose Assembly with P.O.L. Male Ends
Marshall Excelsior ME318P Pol Adapter Full Flow
Homewerks VGV-2LH-B4CB Gas Ball Valve x Female Thread, Brass, 3/4-Inch, 0.75-Inch
Flextron FTGC-YC34-36P 36" Flexible Yellow Epoxy Coated Gas Line Connector with 1" Outer Diameter and 3/4" FIP x 3/4" MIP Fittings, Stainless Steel
Camco 59953 Propane Fitting - 1/4" Male NPT x 1/4" Female Inverted Flare
Emerson-Fisher LP-Gas Equipment R622H-JGJ 1st Stage Regulator, 8-12 psig Spring, POL x 3/4" NPT
Harvey 017065 Gas Line PTFE Thread Seal Tape
Emerson-Fisher LP-Gas Equipment R632A-BCF Integral 2-Stage Regulator, 9-13" W.C Spring, 1/4" x 1/2" NPT
Emerson-Fisher LP-Gas Equipment R642-DFF 2nd Stage Regulator, Side Outlet, 9-13" W.C Spring, 3/4" x 3/4" NPT
Emerson-Fisher LP-Gas Equipment R632A-CFF Integral 2-Stage Regulator, 9-13" W.C Spring, 1/4" x 3/4" NPT