HANDSKIT Electrical Multimeter Test Leads Set with Alligator Clips

HANDSKIT Electrical Multimeter Test Leads Set with Alligator Clips

• 42-STRAND COPPER MULTIMETER LEADS: Each multimeter lead uses a 42-strand copper conductor to support stable signal transmission and currents up to 10A. Internal nylon reinforcement helps reduce conductor strain when these multimeter test leads are bent repeatedly during routine electrical measurements.
• FLEXIBLE SILICONE ELECTRICAL TEST LEADS: These flexible test leads use double-layer silicone insulation and internal PA nylon reinforcement to help protect the conductor during repeated bending. The insulated multimeter cables remain flexible for regular meter testing. Inspect before each use and replace any lead with cut, cracked, melted or damaged insulation.
• NICKEL-PLATED MULTIMETER PROBES: Nickel-plated copper multimeter probes provide firm contact and a stable measurement response. Secure test probes and plugs help maintain consistent contact during voltage, resistance and continuity checks. Keep the probe tips clean and dry during storage to reduce oxidation.
• CAT II 1000V AND 10A METER LEADS: These multimeter and voltmeter leads are rated CAT II 1000V and up to 10A for general measurements. The included 2 mm alligator clips are rated up to 10A. When connected to a 20A probe, the setup must not exceed the lowest-rated component: 10A while the clips are attached.
• MULTIMETER REPLACEMENT LEADS: Made by a manufacturer with more than 10 years of experience in multimeter accessories, these DMM test leads are intended for compatible digital multimeters with matching connectors and ratings. Inspect the leads, probes, plugs and clips before use; do not use any loose or damaged component.