ElecGear 2x TMR Joystick Replacement for ASTRO C40 TR Controller, PCB Assembly Module with TMR Hall Control Stick Replacement for Analog Stick

ElecGear 2x TMR Joystick Replacement for ASTRO C40 TR Controller, PCB Assembly Module with TMR Hall Control Stick Replacement for Analog Stick

• [TMR Joystick for C40 TR] – The joystick PCB assembly works with ASTRO C40 TR controller. It’s a direct repair replacement for stock analog stick module. With the newest TMR stick sensors inside, the control stick delivers higher sensitivity and accuracy. No more wear of traditional carbon film resistor, smoother movement and longer lifespan
• [About Calibration] – Swap the old analog stick PCB with new TMR stick PCB. Gently screw in the 2 screws. Not too hard for the plastics is fragile. Press and hold the Program Button on the underside for 5 seconds. The controller will rumble once. Wait for 30 seconds. It will rumble once again. The center was reset. Rock the joystick 3-4 circles to calibrate the outer range
• [What’s in box: TMR-C40] – 2x TMR Stick PCB Assembly, 1x T6 Screwdriver. (?1. Controller, the plastic enclosure and screws are NOT included. 2. Please refer to the video on the same product ID of U.S. Amazon for the demonstration of the installation steps.)