EVRBUL Upgraded Impact Drill Bit Socket Wrench 2-in-1 Square Nut Remover 4-Point Impact Adapter Socket for 1 Inch and 1-1/8 Inch Square Nuts

EVRBUL Upgraded Impact Drill Bit Socket Wrench 2-in-1 Square Nut Remover 4-Point Impact Adapter Socket for 1 Inch and 1-1/8 Inch Square Nuts

• 【Fit for】: This 7/16" impact adapter socket is used to remove / install 1 in (26mm) and 1-1/8 in (29mm) square nuts.
• 【Easy to Use】: You can use a 7/16 inch impact drill or 1/2 inch electric drill to drive it, it helps you to remove and install the square nut easily, saving time and effort.
• 【High Quality 40Cr Steel】: Our square nut impact adapter is made of high quallity 40Cr steel, which has excellent wear resistance. In addition, it shows good corrosion resistance in acidic, alkaline and other media, and adapts to various corrosive environments. The surface is blackened to form a dense oxide film on the metal surface, which can well isolate the metal matrix from the outside air, so as to avoid metal rust due to oxidation, it can significantly extend the service life of metal products, so that it is not easy to damage due to rust during use.
• 【Heat Treatment】: After proper heat treatment, the yield strength and tensile strength of 40Cr steel can reach a higher level and can withstand larger loads. At the same time, the good toughness makes it maintain a high stability when it is impacted, and is not easy to fracture or deformation.
• 【Package Included】: 1 × 7/16" Square Nut Impact Adapter Socket.