Dual Barbell Holder for 3x3" Power Rack, No-Drill Rack Mount Barbell Storage Hook, Heavy Duty Steel Barbell Hanger with Foam Padding for Home Gym

Dual Barbell Holder for 3x3" Power Rack, No-Drill Rack Mount Barbell Storage Hook, Heavy Duty Steel Barbell Hanger with Foam Padding for Home Gym

• ✅【Designed for 2x2 Power Rack Uprights】Compatible with 2×2" power rack uprights.Best fit with 5/8" holes, providing the most secure and stable installation for home and commercial gym setups.
• ⚠ 【IMPORTANT: Check Rack Hole Height Before Purchase】This barbell holder relies on the available hole height of your rack to keep the barbell fully off the floor. NOT compatible with racks where all usable hole positions are too low to provide sufficient clearance between the barbell and the ground, even when installed at the highest available hole.? Please confirm your rack’s hole layout and height before ordering.
• ?【5/8" Holes = Best Fit | 1" Holes Use with Caution】5/8" holes are the most ideal fit for this holder (M14 bolt design). However, a slight looseness may occur depending on rack tolerance. ⚠ If you are sensitive to any movement or prefer a perfectly tight fit, 1" hole racks are not recommended.
• ?【No Drilling – Easy Tool-Free Installation】 No wall drilling required. Installs directly onto your rack upright using a screw-tightened design — quick setup with no extra hardware.
• ?【Heavy-Duty Steel with Bar Protection】Built from reinforced steel with a durable powder-coated finish. Integrated protective padding helps prevent damage to your barbell’s knurling during storage.