Dream Lighting 12volt LED Dome Light for RV Trailer Boat Interior Cabin Kitchen Overhead Downlights-4.5inch Ceiling Light Fixture, Warm White, Pack of 10
Product Description
Dream Lighting 12volt LED Dome Light for RV Trailer Boat Interior Cabin Kitchen Overhead Downlights-4.5inch Ceiling Light Fixture, Warm White, Pack of 10
- This amazing LED Mushroom Dome Light is for interior caravan, motor-home, and RV interior roof light applications.
- High intensity LEDs produce nice light output without casting shadow. PC lens cover softens the light. It is designed to replace the traditional energy sucking pancake lights.
- It is a small light but with great performance. It fits narrow space very well. So it will light up anywhere you want.
- To make sure safe and stable operation, we used aluminum heat sink for the light.
- Surface mount design is convenient for installation. The clever lens cover will hide the mounting screws after installation. The light will look neat and clean.
Pack of ten!
Commercial 12V LED dome lights are here! They have simple design but practical lighting for your vehicle ceiling. This light consumes 3.8 watts to emit bright 230 lumens thanks to advanced LED technology. LED is a reliable lighting source which has long life span of 50,000 hours. Circuit board installed on an aluminum plate to provide efficient heat sink. A lens is to soften glare lighting. You could enjoy the bright and soft lighting in your vehicle.
Features
A. Designed to upgrade your RV interior pancake light
B. Fits for under cabinet, down light applications
C. Thin body - To fit places where space is limited
D. Frosted PC Lens - soft and even light distribution
E. Aluminum Base Plate - efficient heat sink to support the stable performance
Specifications
Operating voltage: 12volt DC
Wattage: 3.8W
Current draws: 315mA
Lighting color: warm white
Lighting angle: 120 degrees
Brightness level: 230 lumens
Base diameter: 4.5 inch
Long Lifespan - more than 50,000 hours
No mounting hardware included
Surface mounted design:(Black wire for positive and white wire for negative/ground)
1. Rotate the lens clockwise to detach from the light body. Then you can see the screw holes for surface mounting
2. Mark the location of light. Turn off the electricity at the main electricity panel. Wire the light. Fix the light with screws. Cover the lens by rotating it as the instructed direction. Turn on the electricity and confirm proper operation.









