Donepart 1641NR Bearing 1x2x0.56in, Steel, Snap Ring 4-Pack

Donepart 1641NR Bearing 1x2x0.56in, Steel, Snap Ring 4-Pack

• 1641NR — 1 Inch Bore with Snap Ring Groove: 1 inch (25.4mm) inner bore x 2 inch (50.8mm) OD x 0.5625 inch (14.3mm) width. The NR suffix means this bearing has a snap ring groove for easy axial positioning. 4 bearings in the pack. Fits garage door torsion spring center brackets, zero turn mower wheel hubs, go kart axles, and wagon wheels.
• Grease It Before You Run It: These bearings ship with a light factory oil coating — not a full grease pack. The dust covers are removable. Before installation, pull the covers, pack the bearing fully with a quality bearing grease, and press the covers back on. 5 minutes of prep gives you a bearing that stands up to water spray, dirt, and heavy loads for the long term.
• Chrome Steel, Deep Groove, Handle Both Radial and Axial Loads: GCr15 chrome steel races and balls. Deep groove raceway geometry handles the combined loads common in mower spindles, wagon axles, and garage door torsion systems — radial load from the weight, axial load from turning and cornering.
• Snap Ring Simplifies Install and Keeps the Bearing in Place: The built-in snap ring groove lets you lock the bearing axially without a press fit or external retainer. Slide the bearing into the housing, clip the snap ring into the groove, and it stays where you put it. No special tools needed beyond standard snap ring pliers.
• Proven on the Job: Customers report direct fitment on Bobcat walk-behind mowers, Kubota zero turns, go kart rear axles, and garden wagon wheels. Measure your old bearing before ordering — 1" bore, 2" OD, 0.5625" width, with snap ring groove = this is the one.