Ceiling Fan Mounting Bracket, Box Mount Kit, Adjustable Bar Hanger, Brace

Ceiling Fan Mounting Bracket, Box Mount Kit, Adjustable Bar Hanger, Brace

• ADJUSTABLE 16 TO 24 INCH BAR HANGER — The hanger bar telescopes to fit any joist space from 16 to 24 inches on center, which covers standard residential framing and most of what you find when the ceiling opens up. Slide it out, land it on both joists, and drive the screws. One part number instead of guessing at the spacing before you go up the ladder, and no shimming a fixed-length bracket to make it reach.
• RATED FOR REAL FAN WEIGHT — At 16 inch span the bracket carries up to 70 pound fans and 110 pound light fixtures. At 24 inch span it is rated for 35 pound fans and 50 pound fixtures. Check your fan weight against the span you actually have before you order. A fan hangs on this bracket for twenty years and cycles a load every time it runs, so the rating is the number that matters most.
• WELDED STEEL CONSTRUCTION — The box is welded rather than crimped, so the corners do not open up when you torque the bracket down or hang weight from it. Inside there is ample room for your conductors and connectors, which matters on a fan install where you are landing hot, neutral, ground, and often a separate light lead in the same box.
• TWO PRE-ASSEMBLED NMSC CLAMPS — Both cable clamps come already installed in the box, sized for non-metallic sheathed cable or flexible metal conduit. Two 1/2 inch knockouts give you the entry points. Nothing to add, nothing to buy separately, and no fishing a loose clamp out of the bottom of the box with the fixture half-supported over your head.
• ADHESIVE PADS HOLD IT IN PLACE — The bracket has adhesive padding that temporarily sticks it to the ceiling while you drive the mounting screws. That is the difference between a two-person job and a one-person job. Anyone who has tried to hold a bar hanger level against a joist with one hand and run a driver with the other will understand why this is on the list.
• RAISED GROUND AND COMBINATION SCREWS — The ground provision is raised so the screw is easy to reach and easy to see once the box is up in the ceiling. The mounting screws use combination heads, so a flat blade or a Phillips both work and you are not sent back down the ladder for a different driver.
• THREE PACK SIZES — Available as a single, a 4-pack, and an 8-pack from this listing. Single for one room or one replacement, 4-pack for a whole-house fan job or a flip, 8-pack for builders and contractors doing multiple units. Same bracket, same box, same ratings, whichever count you choose.
• AIRMONT PRODUCTS QUALITY — Built for reliability and durability on every electrical installation, because electricians know us, and we know electricians.