COREAX 14 Inch Heavy Duty Folding Shelf Brackets, 2 Pack, Stainless Steel

COREAX 14 Inch Heavy Duty Folding Shelf Brackets, 2 Pack, Stainless Steel

• Wide, easy-release tabs - A broad, flat press surface gives your fingers more contact area when lowering a fold-down shelf or table. The brackets lock open at 90 degrees for everyday use, then release when you press the tabs. Support the board as you release both brackets, and keep fingers clear of the folding joints.
• Extra workspace, less permanent clutter - Create a wall-mounted laundry folding table, garage workbench extension, RV flip-up counter, camper van prep surface or compact kitchen shelf. This collapsible support lets you raise the surface when needed and fold it down when finished. Plan the installation around a suitably reinforced wall or cabinet, not just the available space.
• 201 stainless steel, brushed finish - These 14 inch brackets support up to 300 lb per pair when properly installed. A practical choice for laundry rooms, kitchens, garages and covered outdoor utility areas. Your shelf's usable load also depends on the board, fasteners, bracket spacing and supporting structure; a bracket rating is not a rating for the complete installation.
• Built around your board - Choose the bracket size for your board depth and mounting space; the named inch size is nominal, so check the actual arm dimensions. Install both brackets level and parallel into studs, solid wood, concrete or reinforced cabinetry. Match the fasteners to the substrate, and leave room to reach both release tabs after fitting the board.
• Ready for your DIY surface - Each set includes 2 folding shelf brackets, 12 M4 flat-head self-tapping screws and 6 expansion bolts. Choose your own board for a laundry station, workshop shelf or RV counter extension; shelf board or tabletop is not included. Match screw length to board thickness, and periodically check the mounting fasteners and locking action.