Baileigh Tube and Pipe Notcher (TN-250)
Product Description
Baileigh Tube and Pipe Notcher (TN-250)
- Patented self-centering vise can clamp down anywhere on tube, including the middle of bends
- Fully-adjustable axis accommodates almost any notch combination
- Carriage pivots up to 220° left to right, so you can come from the "back side" of the notch
- Two slotted mounting rails move up and down with scales for offset notches up to 1" and allow for almost any position of the bearing block
- Large engraved angle finder helps you get those back-side notches lined up
- 1.25" Thompson shaft rides in sealed and oiled needle bearings for smooth performance
- Heavy-duty .75" steel plate backbone and all-interlocking components create a rigid platform that reduces vibration and prolongs the life of hole saws
Baileigh tube notcher has a unique self centering radial vise that allows the operator to clamp down on tubes and more in any direction, including in the middle of a bend. Also by using a truly self centering vice, the tube notcher is the only hole saw tubing notcher that is always centered left to right and up and down, no matter what size tube or pipe you have. the back bone is made from heavy duty 3/4-inches steel plate and all component inter lock to create a very rigid platform to reduce vibration and prolong the life of the hole saws. The shaft of the tube notcher is a 1-1/4-inches Thompson shaft that rides in sealed and oiled needle bearings. Unlike other tube notchers in this category, the two ends of the shaft are completely replaceable. This helps save time and money. The tube notcher can notch up to 2-1/2-inches OD and allows large degree angles. The notching carriage can pivot up to 230 degrees allowing the operator to come from the "back side" of the notch. A large degree plate helps get these back side notches lined up. The TN-250 also has a fully adjustable axis to accommodate almost any notch combination considering the pivot moves left to right up to 230 degrees, there are two slotted mounting rails for almost any position of the bearing block, and finally we have the easily adjusted position for up and down. Notching capacity (OD): 1-inches - 2.5-inches; Angle adjustment: infinite; Power: 1/2-inches (12.7 mm) hand drill.
