Assembled I3 Mega V5 Upgrade J-Head Hotend 12V40W and 3X 0.4mm Nozzle, 2X Silicone Sock, 1x Heatblock Compatible with 3D Printer ANYCUBIC I3 MEGA, I3 MEGA X, Mega S, Mega Pro 1.7 mm Filament Extruder

Assembled I3 Mega V5 Upgrade J-Head Hotend 12V40W and 3X 0.4mm Nozzle, 2X Silicone Sock, 1x Heatblock Compatible with 3D Printer ANYCUBIC I3 MEGA, I3 MEGA X, Mega S, Mega Pro 1.7 mm Filament Extruder

• Package: 1 Set assembled I3 Mega hotend V5 J-head hotend (Contained: PTFE tube, heater, NTC 100K thermistor, throat, pneumatic connector, brass nozzle, mega V5 radiating pipe and heater block), 3 x V6 nozzles, 2 x V5 silicone socks, 1 x V5 heater block
• Compatible with Anycubic Mega Series: This V5 J-head hotend is perfectly compatible with ANYCUBIC I3 MEGA, I3 MEGA X, Mega S, Mega Pro 3D Printer
• Assembled Mega Pro Hotend: Teflon tube, 12V heater and NTC100K thermistor are pre-assembled in hotend. Teflon tube goes through pneumatic joint and down to the nozzle, thus the feeding is smooth and clogging is reduced. Working temperature up to 250℃
• Easy to Use, More Compatibility: The heater wire and thermistor wire come with suitable connetors, simply remove old J-head hotend and replace with the new J-head, plug wires to the electronic board, then ready to print
• Tips: 1. Before installed, please check parts whether loose in transit. 2. It is suggested to re-level your hot bed after installing this print head