Acid Tactical® 4PK Camouflage Spray Paint Camo Gun Stencils Adhesive & Mylar Assorted Skulls

Acid Tactical® Spray painting Stencils

COMBO PACK - Adhesive Punisher Skulls & 3 sheets Mylar Asst. Skulls

PUNISHER SKULL are Easy Peel - Stick on, Paint, Peel Off

4 stencils as shown in our main image.

Designed for use on Rifles, Shotguns, Pistols. Can be used on Plastic, Metal, Wood, etc..

.25mm Vinyl Sheets & .3mm Mylar Sheets

Can be used with all types of paints including, Rattle can, Duracoat, Cerakote, water, and oil based paints.

ADHESIVE STENCILS

Our adhesive easy peel stencils will not leave sticky glue residue behind. They were designed to remove cleanly and not effect the paint.

Stencils are heat resistant on both metal and polymers. They do not shrink on ABS and Polymers when flash curing like the yellow avery paper. They leave little to no adhesive behind so no messy clean up.

For angled surfaces: When shaping around corners use larger stickers and allow half of the sticker to lay on each plane. If small sections of the design overlaps a corner it may not adhere well. Use scissors to trim any excess that doesn't want to adhere

Useful Tools:

Exacto knife - Can be used to remove sticker and also to form sticker in tight angles. Scissors - To trim excess stencil

MYLAR STENCILS

Mylar stencils are spray through type. You can use a whole sheet at one time or isolate a single skull using scrap paper and masking tape. This type of stencil is reusable and washable.

What you get.

4 - 9x14" Sheets - 1 Adhesive Punisher skulls sheet and 3 spray through Mylar assorted skull sheets.

Each sheet is a unique design.

Specifications:

Material: Adhesive - High Temp Vinyl film Spray through - Mylar
Thickness: .25mm / .30mm
Length: 14"
Width: 9"