6PCS Car Ball Joint Boot Replacement,Rubber Car Tie Rod Boot Provides Sealed Protective Barrier,3 Sizes of Cars Tie Rod End Boots for Steering Suspension Systems

6PCS Car Ball Joint Boot Replacement,Rubber Car Tie Rod Boot Provides Sealed Protective Barrier,3 Sizes of Cars Tie Rod End Boots for Steering Suspension Systems

• Small Medium Large in One Kit: This tie rod boot kit gives you 2 small boots (1.38x0.81 inch), 2 medium (1.64x0.91 inch), and 2 large (1.72x1.1 inch). Six boots total. Measure your old boot diameter and height before ordering. Having three sizes means you can fix multiple vehicles
• Good Seal: Road dirt, sand and water are bane of any ball joint. Our ball joint boot locks them out completely. The joint stays packed with grease instead of grinding paste. Steering stays tight. Suspension stays quiet. This boot is an essential car accessory
• Rubber Materials: These ball joint boot replacements are made from rubber that handles extreme conditions. Freezing weather? The material stays flexible. Engine heat and summer pavement? No hardening or cracking. The rubber also resists oil and grease damage. One installation lasts for years of daily driving
• Works on Most Popular Vehicles: This tie rod end boot set fits most sedans, SUVs, and light trucks. Use on steering tie rod ends, rack and pinion boots, lower ball joints, and control arm dust covers. Always compare our sizes to your original part
• 3-step Installation: Step A - detach the old torn tie rod boot and wipe the ball joint clean of old grease and dirt. Step B - apply grease to the inside of the new boot and to the ball joint surface. Step C - slide the new boot over the ball joint until it snaps into the retaining groove