Stemedu 5PCS RCWL-0516 Microwave Radar Motion Sensor Module, 5-7m Detection Distance, Through-Wall Human & Animal Movement Detector for Arduin0 ESP8266 NodeMCU Wemos

Description:
Wide operating voltage range: 4-28V
Can output 3.3V power supply
Blocking time, adjustable distance
Using special signal processing control chip RCWL-9196
Compared with the traditional infrared induction PIR, the penetration detection ability

About pin header:
CDS = No connection
VIN = 5vdc (+) (9v battery also Ok)
OUT = 3.3vdc signal out when triggered
GND = 0vdc (-)
3V3 = No connection (in most applications)

C-TM: Adjust repeat trigger time (default 2 s). Adding a capacitor will give a longer repeat trigger time.
R-GN: Detection distance adjustment (default 7 m). Adding a resistor the detection distance will become shorter. If connected with a 1-MΩ resistor, detection range is about 5 m.
R-CDS: By adding a resistor (in parallel with the internal 1-MΩ resistor), user can change the light detection threshold as per individual requirement. This is applicable only when a light sensor is soldered in its pads (CDS) on the front of the circuit board. A 47-100K resistor works fine with standard 5-mm LDRs

Package Includes:
5 X RCWL-0516 Module Microwave Radar Sensor
5 X 4P Bend Pin Headers

FAQ:
Q: Can you use the RCWL-0516 with an ESP8266? Or will you get random false positive results?
A: I've done a short term test with the ESP8266 on a NodeMCU board. It seems to work just fine. The ESP greater Version 12-E is shielded and is FCC certified. So it should, by definition, not interfere with other electronics. However, one viewer reported random false positive results on a long shot.
Q: Is the water in the human body responsible for the detection?
A: Probably. I tested it with one empty and one water filled bottle. And even with a cat. And it seems that the bigger the object the further away it can be detected.