4PCS M10x1.0-32.1mm Car Brake Bleeder Screw Kit,Essential Car Brake Bleeder Valve with 4PCS Brakes Bleeders Caps,Sturdy Cars Brakes Caliper Bleeders Screw Replacement

4PCS M10x1.0-32.1mm Car Brake Bleeder Screw Kit,Essential Car Brake Bleeder Valve with 4PCS Brakes Bleeders Caps,Sturdy Cars Brakes Caliper Bleeders Screw Replacement

• Size Details: This brake bleeder screw set comes with 4 screws and 4 caps. Thread spec is M10x1.0-32.1 mm. Please measure your old bleeder before ordering to confirm fit. The kit comes in a generous quantity to meet your long-term needs, requiring infrequent replacement
• Older Part Swap: The bleeder valve is a critical piece of your brake system. When the original bleeder ages or gets damaged, this product steps in as a direct replacement. Swapping it out helps you avoid problems that come from worn screws, such as poor sealing or difficulty during brake fluid changes
• Cap Protection: Do not underestimate these small caps. They fit tightly over the bleeder screw head. Their job is to block dust, sand, and other outside debris from getting inside the screw. This simple barrier helps your bleeder screws last much longer by keeping clean
• Material Choice: The brake bleeder valve screw uses iron for its main body. Iron gives you good hardness and strength to handle long term wear without breaking. The cap uses soft rubber that fits the screw snugly. This rubber also holds up well over time, so the cap stays flexible and keeps its protective fit for many months
• Install Steps: Locate the original bleeder screw on your vehicle brake caliper. Replace the old part with this new brake caliper bleeder screw. Then put the protective cap on. The cap has a one piece connecting ring that keeps it attached to the screw. This design means you will not lose the cap while working on your brakes