3KW BT30 220V ATC Water Cooled Spindle Motor Automatic Tool Changer 24000rpm 400Hz 100mm with 3.7KW Inverter VFD Drive CNC Kit for CNC Router Milling Engraving Machine

3KW BT30 220V ATC Water Cooled Spindle Motor Automatic Tool Changer 24000rpm 400Hz 100mm with 3.7KW Inverter VFD Drive CNC Kit for CNC Router Milling Engraving Machine

• Model: RTM100-30-24Z/3.0-220V; This spindle is built-in type spindle motor,built-in three asynchronous motors,by the inverter control; This spindle built-in automatic tool change device,the spindle with one BT30-ER25 Tool holder
• Parametes of Motor: Voltage is 220V; Speed: 3000-24000rpm; Frequency: 400Hz; Motor pole: 2 Poles; Rated power: 3.0KW (S1); Peak power: 4.2KW (S6); Rated torque: 190N.cm; Peak torque:260N.cm; Current: 7.6A
• Parametes of VFD: 3.7KW Fuling VFD Inverter; Input Voltage: 220V+/-15%; Output Voltage: 220V; Input: Single phase or Three phase; Output: Three phase; Outpute Frequency: 0-1000Hz; Input Frequency: 50-60Hz; Current:15A; Wirings: R S T any 2 pins connect to 220V AC single phase power supply
• Bearings: The bearing of spindle use grease lubricated angular to contact bearings;The spindle use forced cooling mode to cooling motor,front and rear bearings;The spindle built-in PTC 140 temperature sensor
• The spindle built two 0-24V, PNP Sensors: Response tool clamp signal, when the tool holder is hang, black sensor output signal; Response tool open signal, when the tool jaws open, black sensor output signal; This ATC kit can be used to work on wood, castings, aluminum, glass, etc and other processing